LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 954 (Lighting Systems) >> Diagnostic Information and Procedures >> Clearance Lamps Inoperative

Clearance Lamps Inoperative

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Clearance Lamps Inoperative

Step Action Yes No
Schematic Reference:  Exterior Lights Schematics  
Connector End View Reference:  Lighting Systems Connector End Views   or  Body Control System Connector End Views  in Body Control System.
1 Did you perform the Lighting Systems Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Lighting Systems 
2 Turn ON the park lamps.
Do the clearance lamps illuminate?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 Are the park lamps illuminated? Go to Step 4  Go to Park, License, and Tail Lamps Inoperative 
4 Are all clearance lamps inoperative? Go to Step 7  Go to Step 5 
5 Test the clearance lamp supply voltage and ground circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 6 
6 Inspect for poor connections at the harness connector of the clearance lamp. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 8 
7 Repair the interior park lamps supply voltage circuit of the clearance lamps for a short to ground, a high resistance, or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you complete the repair?
Go to Step 9  -
8 Replace the affected clearance lamp bulb.
Did you complete the replacement?
Go to Step 9  -
9 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3