LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 953 (Horn System) >> Repair Instructions >> Horn Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Ensure that the black side of the horn is facing forward on the vehicle.
  1. Install the horn (2) to the radiator support (1).
    2. Fig 1: Horn & Radiator Support
    GM331104Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the horn bolt.

    Tighten:  Tighten the horn bolts to 9 N.m (80 lb in).

  3. Connect the horn electrical connector.
  4. Lower the vehicle.
  5. Install the washer reservoir. Refer to Washer Pump/Reservoir Replacement in Wipers/Washer Systems.
  6. Install the battery tray. Refer to Battery Tray Replacement in Engine Electrical.
  7. Install the battery. Refer to Battery Replacement in Engine Electrical.
  8. Close the hood.
scientia non olet · About LEMON Manuals