LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 951 (Wiring Systems - Introduction) >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right side end panel.
  2. Push in the tabs in order to remove the fuse block.
  3. Pull out the fuse block out of the I/P in order to remove the retaining bolt.
  4. Loosen the bolt.
  5. Insert a screw driver between the wire harness block and fuse block in order to separate.
  6. Separate the fuse block from the I/P harness block.
  7. Remove the I/P wiring harness block from the vehicle.
    8. Fig 1: Right Instrument Panel Electrical Center Or Junction Block
    GM375032Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals