LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 951 (Wiring Systems - Introduction) >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuse block to the I/P wire harness block.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the retaining bolt.

    Tighten:  Tighten the bolt to 6 N.m (53 lb in)

  3. Install the fuse block to the I/P until it clicks in place.
    4. Fig 1: Installing Fuse Block To I/P
    GM375030Courtesy of GENERAL MOTORS CORP.
  4. Connect the wiring connectors to the fuse block.

    Refer to Electrical Center Identification Views to ensure the right connections are made.

    5. Fig 2: Connecting Wiring Connectors To Fuse Block
    GM375032Courtesy of GENERAL MOTORS CORP.
  5. Install the right side end panel.
scientia non olet · About LEMON Manuals