LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 951 (Wiring Systems - Introduction) >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left side end panel.
  2. Remove the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
  3. Disconnect all the wiring connectors from the fuse block.
  4. Remove all the fuses.
  5. Remove the turn signal relay from the back of the fuse block.
  6. From behind the fuse block, remove the retaining bolt.
  7. Insert a screw driver between the fuse block and the wire harness block to separate.
  8. Push on the retainers in order to remove the fuse block.
  9. Remove the fuse block from the vehicle.
    10. Fig 1: Left Instrument Panel Electrical Center Or Junction Block
    GM386487Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals