LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 951 (Wiring Systems - Introduction) >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuse block onto the I/P assembly until it clicks in place.
  2. Install the wire harness block to the back of the fuse block.
    3. Fig 1: Left Instrument Panel Electrical Center Or Junction Block
    GM386487Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolt.

    Tighten:  Tighten the bolt to 6 N.m (53 lb in).

  4. Install the turn signal relay to the back of the fuse block.
  5. Using the wiring diagram on the cover of the fuse panel, install the fuses.
  6. Install the electrical connectors.
  7. Install the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
  8. Install the left side end panel.
scientia non olet · About LEMON Manuals