LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 951 (Wiring Systems - Introduction) >> Diagnostic Information and Procedures >> Push to Seat Connectors >> Terminal Repair

Terminal Repair

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Slip the cable seal away from the terminal.
  2. Cut the wire as close to the terminal as possible.
  3. Slip a new cable seal onto the wire.
  4. Strip 5 mm (3/16 in) of insulation from the wire.
  5. Crimp a new terminal to the wire.
  6. Solder the crimp with rosin core solder.
  7. Slide the cable seal toward the terminal.
  8. Crimp the cable seal and the insulation.
  9. If the connector is outside of the passenger compartment, apply grease to the connector.
scientia non olet · About LEMON Manuals