LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 951 (Wiring Systems - Introduction) >> Diagnostic Information and Procedures >> Micro-Pack 100W Connectors >> Replacement Procedure

Replacement Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

After the terminal is crimped to the wire perform the following procedure in order to replace Micro-Pack 100 terminals.

  1. Slide the new terminal into the correct cavity at the back of the connector.
  2. Push the terminal into the connector until it locks into place. The new terminal should be even with the other terminals. Insure that the terminal is locked in place by gently pulling on the wire.
  3. To assemble the connector, reverse the Terminal Removal Procedure.
scientia non olet · About LEMON Manuals