Adjustment & Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1999 Oldsmobile Bravada, 1999 GMC Sonoma, 1999 GMC Jimmy, 1999 GMC Envoy, and 1999 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Install PNP switch onto manual shaft. Install PNP switch retaining bolts, but do not tighten. Position PNP Switch Alignment Tool (J-41364-A) onto PNP switch. Rotate PNP Switch Alignment Tool until upper locating pin is lined up with slot on top of PNP switch. Tighten PNP switch retaining bolts to 18 ft. lbs. (25 N.m). Install transmission control lever onto manual shaft. Install and tighten transmission control lever retaining nut to 18 ft. lbs. (25 N.m). Lower vehicle. Check switch for proper operation. Repeat procedure as necessary until engine starts in Park and Neutral positions only.