LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 946 (Transfer Case (NVG226-NP8)) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the rear output shaft seal.
  2. Using the J 37668-A, install the rear output shaft seal.
    3. Fig 1: Installing Rear Output Shaft Seal
    G01705758Courtesy of GENERAL MOTORS CORP.
  3. Install the rear propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - REAR in Propeller Shaft.
    4. Fig 2: Installing Rear Propeller Shaft
    G01705759Courtesy of GENERAL MOTORS CORP.
  4. Inspect the transfer case fluid level. Refer to Transfer Case Fluid Replacement .
  5. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
scientia non olet · About LEMON Manuals