LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 944 (Rear Drive Axle) >> Repair Instructions >> Vent Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the vent hose to the clip attached to the frame.
    • Route the same way as when removed.
    • Ensure that the hose is free of kinks and is routed clear of sharp objects.
    • Ensure that the vent is not plugged.
    2. Fig 1: Installing Vent Hose To Clip Attached To Frame
    G01705375Courtesy of GENERAL MOTORS CORP.
  2. Install the vent hose to the top of the rear axle.
    3. Fig 2: Installing Vent Hose To Top Of Rear Axle
    G01705376Courtesy of GENERAL MOTORS CORP.
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals