LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 940 (Body Rear End) >> Repair Instructions >> Strut Replacement - Rear Lift Window Panel (4-Door) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the endgate window struts to the endgate window.
  2. Install the upper end of the endgate window struts to the ball joint. Press in to place until fully seated.
  3. Install the upper end of the endgate window struts to the ball joint. Press in to place until fully seated.
  4. Remove the support from the endgate window.
  5. Close the endgate window.
    Fig 1: Installing Lower End Of Endgate Window Struts To Ball Joint
    G01478246Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals