LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 940 (Body Rear End) >> Repair Instructions >> Strut Replacement - Rear Lift Window Panel (2-Door) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
  1. Open and support the endgate window.
    NOTE: Refer to LIFTGATE ASSIST ROD NOTICE in Cautions and Notices.
  2. Remove the retainer from the hinge pin at the upper end of the endgate window strut.

    Discard the retainer.

  3. Remove the hinge pin from the upper end of the endgate window strut.

    Discard the hinge pin.

  4. Lift up the retainer clips on the endgate window struts using a small flat- bladed tool.
  5. Remove the lower end of the endgate window struts from the ball joint.
  6. Remove the endgate window struts from the endgate window.
    Fig 1: Endgate Window Struts
    G01478243Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals