LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 940 (Body Rear End) >> Repair Instructions >> Pullstrap Replacement - Lift Gate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the liftgate assist handle to the liftgate trim panel.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the screw that retains the liftgate assist handle to the liftgate trim panel.

    Tighten 

    Tighten the screw to 1.9 N.m (17 lb in).

    Fig 1: Liftgate Assist Handle
    G01478209Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals