LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 940 (Body Rear End) >> Repair Instructions >> Lock Striker Replacement - Lift Gate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the liftgate striker.
  2. Install any spacers to the vehicle.
  3. Install the liftgate striker backing plate.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the bolts that retain the liftgate striker to the vehicle.
    Fig 1: Liftgate Striker
    G01478289Courtesy of GENERAL MOTORS CORP.

    Tighten 

    Tighten the bolts to 22 N.m (16 lb ft).

scientia non olet · About LEMON Manuals