Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the air temperature actuator-right.
- Tighten the air temperature actuator-right retaining screws.
Tighten: Tighten the screws to 1.9 N.m (17 lb in).
- Install the air temperature actuator-right electrical connector.
- Install the I/P carrier. Refer to INSTRUMENT PANEL (I/P) CARRIER REPLACEMENT in Instrument Panel, Gages, and Console.
- Recalibrate the air temperature actuator on vehicles equipped with automatic climate control (C68). Refer to Re-Calibrating Actuators (Primary) Re-Calibrating Actuators (Auxiliary HVAC) .
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.