LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 938 (Seat System) >> Repair Instructions >> Seat Back Replacement - Front (Bench Seat) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat back to the lower frame.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the seat back pivot bolt.

    Tighten 

    Tighten the seat back pivot bolt to 47 N.m (35 lb ft).

  3. Install the recliner assembly. Refer to SEAT BACK RECLINER REPLACEMENT - Front 
  4. Install the seat to the vehicle. Refer to SEAT REPLACEMENT - Bucket  or SEAT REPLACEMENT - Bench .
    Fig 1: Installing Seat Back To Lower Frame
    G01478016Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals