Removal Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the filler strip adhesive ends from the bumper.
- Pry the filler strips retaining tabs from the bumper.
- Remove the bumper filler strip.
- Remove all adhesive from the bumper using 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
- Clean the bumper surface using Varnish Makers and Painters (VMP) naphtha and allow to air dry.