LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 934 (Stationary Window System) >> Repair Instructions >> Windshield Side Reveal Molding Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the reveal molding to the windshield pillar.
  2. Install the fasteners.
  3. Install the new weatherstrip tape (if required).
    Fig 1: Installing Reveal Molding To Windshield Pillar
    G01477433Courtesy of GENERAL MOTORS CORP.