LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 933 (Exterior Trim) >> Repair Instructions >> Wheel Opening Flare Replacement -Front (Xtreme) >> Tools Required >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the screws that retain the wheel flare to the vehicle.
  3. Use a heat gun J 25070  in a circular motion for 30 seconds 152 mm (6 in) from the surface in order to heat the flare to 21-31°C (70-90°F).
  4. Use a plastic, flat-bladed tool to remove the flare from the surface.
  5. Remove the flare from the vehicle.
  6. Remove all adhesive from fender using 3M™ ScotchBrite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
  7. Clean the fender using Varnish Makers and Painters (VMP) naphtha and allow to air dry.
    Fig 1: Removing Wheel Flare To Vehicle Retaining Screws
    G01477342Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals