LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 933 (Exterior Trim) >> Repair Instructions >> Wheel Opening Flare Replacement -Front (All Except Xtreme and ZR5) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove 2 nuts securing the lower flare molding to the front bumper assembly.
  2. Remove the fender. Refer to FENDER REPLACEMENT -- FRONT in Body Front End.
  3. Remove the fender to flare retaining nuts inside of the fender from the flare molding studs.
  4. Remove the flare to fender retaining screws around the wheel opening.
  5. Remove the flare from the fender.
    Fig 1: Removing Flare To Fender Retaining Screws Around Wheel Opening
    G01477344Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals