LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Starting System) >> Removal & Installation >> Starter >> Installation (8.1L Engine)

Installation (8.1L Engine)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, and 2002 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. If necessary, install the starter heat shield, nut and bolts. See Figure .
  2. Install the positive cable to the starter. See Figure .
  3. Install the positive cable nut. Tighten the nut to specification. See TORQUE SPECIFICATIONS  .
  4. Install the starter lead to the starter. See Figure .
  5. Install the starter lead nut. Tighten the nut to specification. See TORQUE SPECIFICATIONS  .
  6. Position the starter into place. See Figure .
  7. Install the starter bolts. Tighten the bolts to specification. See TORQUE SPECIFICATIONS  .
  8. Position the front axle mounting bracket bolt until the bolt is fully seated. See Figure .
  9. Install the front axle mounting bracket nut. Tighten the nut to specification. See TORQUE SPECIFICATIONS  .
  10. If necessary, install the oil pan skid plate and bolts. See Figure . Tighten the bolts to specification. See TORQUE SPECIFICATIONS  .
  11. If necessary, install the engine shield and bolts. See Figure . Tighten the bolts to specification. See TORQUE SPECIFICATIONS  .
  12. Lower the vehicle.
    13. NOTE: Clean any existing corrosion from battery terminal bolt flange and battery cable end.
  13. Connect negative battery cable. See Figure . Tighten battery terminal bolt to specification. See TORQUE SPECIFICATIONS  .
scientia non olet · About LEMON Manuals