LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 928 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Console Replacement - Front Floor (Full Length (Auto Trans)) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the shift handle retaining clip at the front of the handle.
  2. Remove the shift handle from the shift lever.
    Fig 1: Removing Shift Handle From Shift Lever
    G01476658Courtesy of GENERAL MOTORS CORP.
  3. Open the console lid.
  4. Remove the console compartment inserts.
    Fig 2: Console Compartment Inserts
    G01476659Courtesy of GENERAL MOTORS CORP.
  5. Remove the transmission select switch (if equipped).
    Fig 3: Transmission Select Switch
    G01476660Courtesy of GENERAL MOTORS CORP.
  6. Remove the nuts that retain the rear of the console.
  7. Remove the cup holder insert.
  8. Remove the screws that retain the front of the console to the vehicle.
  9. Remove the console from the vehicle.
    Fig 4: Removing Front Of Console To Vehicle Retaining Screws
    G01476661Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals