LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 928 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Closeout/Insulator Panel Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the remote control door lock receiver module to the instrument panel sound insulator.
  2. Connect the electrical connector to the remote door lock receiver module.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the screw that retains the instrument panel sound insulator to the cowl panel.

    Tighten 

    Tighten the screw to 1.9 N.m (17 lb in).

  4. Install the screws that retain the instrument panel sound insulator to the knee bolster.

    Tighten 

    Tighten the screws to 1.9 N.m (17 lb in).

  5. Feed the DLC through the hole in the instrument panel sound insulator.
    Fig 1: Installing Instrument Panel Sound Insulator To Cowl Panel Retaining Screws
    G01476619Courtesy of GENERAL MOTORS CORP.
  6. Install the screws that retain the DLC to the instrument panel sound insulator.

    Tighten 

    Tighten the screws to 2.4 N.m (21 lb in).

scientia non olet · About LEMON Manuals