LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 928 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Ashtray Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ashtray housing to the instrument panel.
  2. Position the ashtray housing in order to connect the electrical connectors.
  3. Connect the electrical connectors.
  4. Install the electrical connector retaining clip to the instrument panel.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the screws that retain the ash tray housing to the instrument panel.

    Tighten 

    Tighten the screws to 1.9 N.m (17 Ib. in).

  6. Install the instrument panel trimplate. Refer to TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY .
    Fig 1: Ashtray Housing Retaining Screws
    G01476647Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals