LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 924 (Lighting Systems) >> Repair Instructions >> High Mounted Stop Lamp Replacement (Utility - Endgate Window) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector and push the connector through the hole in the body in order to install the electrical connector.
  2. Insert the rubber grommet into the hole in order to ensure that the hole is properly seated.
  3. Install the high mount stop lamp to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the screws that retain the high mount stop lamp to the endgate window.

    Tighten 

    Tighten the high mount stop lamp screws to 2.5 N.m (22 Ib. in).

    Fig 1: Installing High Mount Stop Lamp To Vehicle
    G01476334Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals