Low Beams-Except ZR2
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
Battery positive voltage to the headlamp switch is supplied by the HDLP SW fuse in the IP fuse block. When the headlamp switch is in the HDLP position, the headlamp power relay coil is energized. A voltage signal is also sent to the body control module (BCM) signaling that the headlamp switch is activated. The headlamp power relay coil is grounded at G102. When the headlamp power relay is energized, the relay supplies battery voltage to the LT HDLP and RT HDLP fuses. Both low beam headlamps are grounded by the multifunction headlamp dimmer switch in the low beam position through the normally closed headlamp grounding relay in the body relay block to G200.