LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 922 (Wiring Systems (General Information)) >> Diagnostic Information and Procedures >> Measuring Frequency

Measuring Frequency

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to TEST PROBE NOTICE in Cautions and Notices.

The following procedure determines the frequency of a signal.

Important:  Connecting the DMM to the circuit before pressing the Hz button will allow the DMM to autorange to an appropriate range.

  1. Apply power to the circuit.
  2. Set the rotary dial of the DMM to the V (AC) position.
  3. Connect the positive lead of the DMM to the circuit to be tested.
  4. Connect the negative lead of the DMM to a good ground.
  5. Press the Hz button on the DMM.
  6. The DMM will display the frequency measured.
scientia non olet · About LEMON Manuals