LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 921 (Manual Transmission - NV 3500) >> Repair Instructions >> Transmission Housing Oil Seal Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission. Refer to TRANSMISSION REPLACEMENT .
  2. Remove the 2 clutch actuator bolts.
  3. Remove the clutch actuator from the input shaft.
    Fig 1: Transmission Housing Oil Seal
    G01979592Courtesy of GENERAL MOTORS CORP.
  4. Remove the 6 bolts from the front bearing retainer.

    Carefully remove the front bearing retainer.

    Fig 2: Front Bearing Retainer
    G01979593Courtesy of GENERAL MOTORS CORP.
  5. Remove the seal from the front bearing retainer by using a hammer and a punch.
  6. Remove the old gasket material from the front bearing retainer.
    Fig 3: Removing Old Gasket Material From Front Bearing Retainer
    G01979594Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals