Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma and 2003 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Install the transmission mount to the vehicle.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the transmission mount to the transmission mounting bolts.
Tighten
- For vehicles equipped with 2.2L, tighten the bolts to 45 N.m (33 lb ft).
- For vehicles equipped with 4.3L, tighten the bolts to 50 N.m (37 lb ft).
  
  Fig 1: Installing Transmission Mount To Vehicle
  Courtesy of GENERAL MOTORS CORP.
Lower the transmission.
Install the transmission mount to the transmission support retaining nut.
Tighten

Tighten the nut to 57 N.m (42 lb ft).
Remove the transmission jack.
Lower the vehicle.

Fig 2: Installing Transmission Mount To Transmission Support Retaining Nut
Courtesy of GENERAL MOTORS CORP.