Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma and 2003 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Important:

Ensure that the shift lever is positioned into the mechanical third or fourth gear prior to removal of the shift housing from the transmission. The transmission must remain in this state when the shift housing is removed.
Do not disassemble the transmission shift housing. Internal parts for this shift housing are not available. Opening the shift housing voids the warranty.
When removing the shift housing from the transmission, use the exposed bolts on the base of the housing.
If equipped, remove the 3 console nuts and console.

Fig 1: Removing Shift Lever From Shift Tower
Courtesy of GENERAL MOTORS CORP.

Remove the shift lever from the shift tower.
Pull back the carpet to access the screws.
Remove the screws securing the boot to the panel.

Fig 2: Removing Screws That Securing Boot To Panel
Courtesy of GENERAL MOTORS CORP.
Remove the 4 bolts securing the shift housing to the transmission.
Remove the shift housing.

Fig 3: Shift Housing
Courtesy of GENERAL MOTORS CORP.