Removal & Installation
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect negative battery cable. Remove drive belt. Remove engine sight shield, if necessary. Disconnect generator harness connector. Slide protective boot down revealing terminal stud. Remove battery output BAT terminal nut. Disconnect battery output BAT cable. Remove generator mounting bolts. Remove generator. To install, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS .