Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the clutch master cylinder.
Raise the vehicle.
Pull back on the connector sleeve and connect the clutch line to the concentric slave cylinder.
Lower the vehicle.

Fig 1: Clutch Master Cylinder
Courtesy of GENERAL MOTORS CORP.
Install the clips securing the clutch line to the dash panel and heat shield.

Fig 2: Installing Clips Securing Clutch Line To Dash Panel & Heat Shield
Courtesy of GENERAL MOTORS CORP.
Position the clutch master cylinder into the cowl panel hole.
Turn the master cylinder 45 degrees counterclockwise to lock the master cylinder.
Connect the wiring harness to the clutch master cylinder start switch.

Fig 3: Turning Master Cylinder 45 Degrees Counterclockwise To Lock Master Cylinder
Courtesy of GENERAL MOTORS CORP.
Connect the master cylinder rod to the clutch pedal.
Bleed the clutch. Refer to HYDRAULIC CLUTCH BLEEDING .

Fig 4: Connecting Master Cylinder Rod To Clutch Pedal
Courtesy of GENERAL MOTORS CORP.