LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 918 (Automatic Transmission Service, Removal & Installation - 4L60-E) >> Repair Instructions >> Transmission Extension Housing Rear Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the inside diameter of the new seal with J 36850  .
  2. Use the J 21426  with a soft faced mallet to install the seal.
  3. Install the seal to the extension housing.
  4. Install the propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - ONE PIECE or PROPELLER SHAFT REPLACEMENT - TWO PIECE in Propeller Shaft.
  5. Remove the drain pan and lower the vehicle.
  6. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to TRANSMISSION FLUID CHECKING PROCEDURE .
    Fig 1: Installing Seal To Extension Housing
    G01980066Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals