LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 917 (Tires And Wheels) >> Repair Instructions >> Tire Hoist and Shaft Replacement (Pickup) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hoist to the rear crossmember. Align the hoist with the rear crossmember and the shaft.
  2. Install the pin and the retainer.
  3. Install the hoist mounting bolts.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the hoist mounting nuts.
    1. Tighten 
    2. Tighten the hoist mounting nuts to 26 N.m (19 lb ft).
  5. Lower the vehicle.
  6. Install the spare tire to the carrier.
    Fig 1: Tire Hoist
    G01467813Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals