LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 917 (Tires And Wheels) >> Repair Instructions >> Tire Hoist and Shaft Replacement (4 Door Utility) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the spare tire from the spare tire carrier.
  2. Raise and suitably support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  3. Remove hoist assembly mounting nuts.
  4. Remove hoist assembly mounting bolts from the frame.
    Fig 1: Tire Hoist Assembly Mounting Nuts & Bolts
    G01467814Courtesy of GENERAL MOTORS CORP.
  5. Remove hoist assembly mounting bolts from the rear crossmember.
  6. Remove hoist assembly from the vehicle.
    Fig 2: Removing Tire Hoist Assembly From Vehicle
    G01467815Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals