LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 913 (Steering Linkage (Non-Rack & Pinion)) >> Repair Instructions >> Idler Arm Replacement (RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the idler arm on the frame.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the idler arm mounting bolts and nut to the frame.

    Tighten 

    Tighten the idler arm mounting bolts and nuts to 108 N.m (79 lb ft).

  3. Install the idler arm to the relay rod ball stud. Ensure that the seal is on the stud.
    Fig 1: Installing Idler Arm Mounting Bolts & Nut To Frame
    G01467339Courtesy of GENERAL MOTORS CORP.
  4. Seat the taper using J 29193  or J 29194. 

    Tighten 

    Tighten the J 29193  or J 29194  to 82 N.m (60 lb ft).

  5. Remove J 29193  or J 29194  from relay rod stud.
  6. Install the new nut to the relay rod ball stud.

    Tighten 

    Tighten the relay rod ball stud nut to 47 N.m (35 lb ft).

  7. Lower the vehicle.
  8. Adjust the front toe. Refer to FRONT TOE ADJUSTMENT in Wheel Alignment.
    Fig 2: Tightening Relay Rod Ball Stud Nut
    G01467340Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals