LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 912 (Power Steering System) >> Repair Instructions >> Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle (700 Gear) >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the nut (3).
  2. Remove the lock washer (2).
  3. Clean the exposed end of the pitman shaft.
  4. Clean the steering gear housing (1).
  5. Use a wire brush to clean the pitman shaft splines.
    Fig 1: Removing Nut & Lock Washer From Pitman Shaft
    G01467273Courtesy of GENERAL MOTORS CORP.
  6. Loosen the adjuster lock nut (1).
  7. Remove the bolts (2).
  8. Remove the nut.
  9. Rotate the stub shaft (6) using a 12-point socket to center the steering gear (7).

    Important:  When removing the pitman shaft assembly, the pitman arm and its components may fall from the steering gear housing. Support the pitman arm and its components while removing the pitman shaft assembly.

  10. Remove the following items as an assembly:
    • The side cover (8)
    • The gasket (3)
    • The pitman shaft (4)
  11. Remove the pitman shaft (4) from the side cover (8).
Fig 2: Removing Pitman Shaft & Gasket From Side Cover
G01467274Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals