LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 912 (Power Steering System) >> Repair Instructions >> Pitman Shaft Seal Replacement - On Vehicle (4WD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the pitman arm. Refer to PITMAN ARM REPLACEMENT (RWD) or PITMAN ARM REPLACEMENT (4WD) .
  2. Remove the snap ring (1) using J 4245  .
    Fig 1: Removing Dust Seal, Return Ring, Washer & Pitman Shaft Oil Seal From Power Steering Gear
    G01467187Courtesy of GENERAL MOTORS CORP.
  3. Remove the following components from the power steering gear (1):
    • The dust seal (5)
    • The return ring (4)
    • The washer (3)
    • The pitman shaft oil seal (2)
  4. Inspect the pitman shaft seal surfaces for roughness or pitting.

    Replace the pitman shaft if the shaft is pitted.

  5. Clean the pitman shaft and seal areas using a wire brush.
scientia non olet · About LEMON Manuals