LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 905 (Engine Mechanical - 2.2L (LN2)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma and 2003 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Allowing the drive belt tensioner to snap into the free position may result in damage to the tensioner.
  1. From under the vehicle, install a 3/8-inch drive wrench on the drive belt tensioner arm.
  2. Rotate the arm counter clockwise.
  3. Remove the drive belt.
  4. Slowly release the tension.
    Fig 1: Rotating Arm Counter Clockwise
    G01976900Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals