LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 900 (Front Drive Axle - 4WD) >> Repair Instructions >> Inner Shaft and/or Housing Replacement - Front Drive Axle (A4WD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to JACKING AND LIFTING in General Information.
  2. Remove the right side wheel drive shaft.
  3. Disconnect the inner axle shaft from the differential case side gear.
  4. Remove the bolts, the nuts, and the washers from the inner axle shaft housing.
  5. Remove the inner axle shaft housing to differential carrier assembly bolts.
  6. Remove the inner axle shaft and housing from the differential carrier assembly.
  7. Remove the inner axle shaft from the inner axle shaft housing.
  8. Remove the inner axle seal and the bearing from the axle housing. Refer to INNER AXLE SEAL AND/OR BEARING REPLACEMENT - FRONT DRIVE AXLE  .
    Fig 1: Installing Inner Axle Shaft Housing Bolts
    G01467999Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals