LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 894 (Bumper System) >> Repair Instructions >> Impact Bar Replacement - Rear Bumper >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear bumper fascia. Refer to FASCIA REPLACEMENT - REAR BUMPER (AZTEK)  or FASCIA REPLACEMENT - REAR BUMPER (RENDEZVOUS)  .
  2. Remove the energy absorber. Refer to ENERGY ABSORBER REPLACEMENT - REAR (AZTEK)  or ENERGY ABSORBER REPLACEMENT - REAR (RENDEZVOUS)  .
  3. Remove the impact bar bolts.
    Fig 1: Removing Impact Bar
    G01515834Courtesy of GENERAL MOTORS CORP.
  4. Remove the impact bar.
    Fig 2: Positioning Impact Bar To Body Using Alignment Pin For Location
    G01515835Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals