LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Automatic Transmission - Servicing - Except ALLISON) >> Removal & Installation >> Park/Neutral Position Switch >> Removal

Park/Neutral Position Switch: Removal

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, and 2002 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the parking brake. Place the transmission into Neutral. Disconnect the negative battery cable. Raise and support the vehicle.
  2. Remove the nut securing the transmission control lever to the manual shaft. Remove the transmission control lever from the manual shaft. See Figure.
  3. Disconnect the wiring harness connector from the PNP switch.
  4. Remove 2 bolts securing the PNP switch to the transmission. Remove the PNP switch from the manual shaft. If the PNP switch did not slide off the manual shaft, file the outer edge of the manual shaft in order to remove any burrs.
scientia non olet · About LEMON Manuals