LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 883 (Engine Exhaust System) >> Repair Instructions >> Exhaust Hanger Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the catalytic converter hanger.
  2. Install the catalytic converter hanger bolts.

    Tighten 

    Tighten the catalytic converter hanger bolts to 35 N.m (26 lb ft).

  3. Install the catalytic converter hanger insulators to the catalytic converter.
  4. Lower the vehicle.
    Fig 1: Installing Catalytic Converter Hanger Bolts
    G01501634Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals