Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Important: The end cap should be installed on the end of the rear wiper blade that will be the farthest from the rear wiper motor drive shaft.
- Install the end cap on the rear wiper blade.
Important: The element must be secure in all the claw sets.
- Install the new element into the rear wiper blade and the end cap until the inner claw set engages the vertebra notches.
- Install the rear wiper blade onto the rear wiper arm. Refer to WIPER ARM REPLACEMENT - REAR .