LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 881 (Seat System) >> Repair Instructions >> Trim Panel Replacement - Rear Seat Back >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the seat back trim panel to the rear seat back.
    Fig 1: Placing Seat Back Trim Panel To Rear Seat Back
    G01518234Courtesy of GENERAL MOTORS CORP.
  2. Install the outer portion of the push-pin retainer to the seat back trim panel.
    Fig 2: Installing Outer Portion Of Push-Pin Retainer To Seat Back Trim Panel
    G01518235Courtesy of GENERAL MOTORS CORP.
  3. Install the push-pin retainer pressing into place until fully seated.
    Fig 3: Installing Push-Pin Retainer
    G01518236Courtesy of GENERAL MOTORS CORP.