LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 881 (Seat System) >> Repair Instructions >> Seat Back Cover Replacement - Rear (Bucket) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear bucket seat. Refer to SEAT REPLACEMENT - REAR BUCKET  .
  2. Remove the rear seat back trim panel. Refer to TRIM PANEL REPLACEMENT - REAR SEAT BACK  .
  3. Remove the rear seat back from the front seat. Refer to SEAT BACK REPLACEMENT - REAR (SPLIT BENCH)  or SEAT BACK REPLACEMENT - REAR (BUCKET)  .
  4. Remove the rear seat headrest. Refer to HEAD RESTRAINT REPLACEMENT - REAR SEAT  .
  5. Remove the J-hook retainer at the bottom of the seat back cover.
    Fig 1: Removing J-Hook Retainer At Bottom Of Seat Back Cover
    G01518237Courtesy of GENERAL MOTORS CORP.
  6. Pull out the rear seat back cover end flaps.
  7. Remove the hook and the loop retainers securing the rear seat back cover to the pad.
    Fig 2: Pulling Out Rear Seat Back Cover End Flaps
    G01518238Courtesy of GENERAL MOTORS CORP.
  8. Remove the rear seat back cover from the seat back, by pulling the seat back cover up and over the pad.
    Fig 3: Pulling Seat Back Cover Up And Over Pad
    G01518239Courtesy of GENERAL MOTORS CORP.
  9. Remove the hog rings from the rear seat back cover to the pad.
  10. Remove the rear seat back cover from the pad.
    Fig 4: Removing Rear Seat Back Cover From Pad
    G01518240Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals