Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Align the locating pins and the retainers from the upper trim panel to the slots in the I/P.
Install the DRL ambient light sensor. Refer to DAYTIME RUNNING LAMPS (DRL) AMBIENT LIGHT SENSOR REPLACEMENT .
If equipped, install the sun load sensor.

Fig 1: Installing Sun Load Sensor
Courtesy of GENERAL MOTORS CORP.
Push forward and down on the upper trim panel to lock into place.
Install the windshield garnish molding. Refer to GARNISH MOLDING REPLACEMENT -- WINDSHIELD PILLAR .

Fig 2: Installing I/P Upper Trim Panel
Courtesy of GENERAL MOTORS CORP.