LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 880 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Head Up Display Switch Replacement (Aztek) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connectors to the switch.
    Fig 1: Connecting Electrical Connectors To Switch
    G01517686Courtesy of GENERAL MOTORS CORP.
  2. Install the driver information center switch to the IP trim plate.
  3. Push the switch assembly to the IP trim plate until the assembly is fully seated.
    Fig 2: Installing Driver Information Center Switch To IP Trim Plate
    G01517687Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals