Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Align the front floor console to the floor.
Connect the required electrical connectors.

Fig 1: Aligning Front Floor Console To Floor
Courtesy of GENERAL MOTORS CORP.
Install the nuts to the front of the front floor console.
Tighten

Tighten the nuts to 6 N.m (53 lb in)

Fig 2: Installing Nuts To Front Of Front Floor Console
Courtesy of GENERAL MOTORS CORP.
Install the nuts to the rear of the front floor console
Tighten

Tighten the nuts to 6 N.m (53 lb in).
Install the front floor console trim plate. Refer to TRIM PLATE REPLACEMENT - FRONT FLOOR CONSOLE (AZTEK) or TRIM PLATE REPLACEMENT - FRONT FLOOR CONSOLE (RENDEZVOUS) .

Fig 3: Installing Nuts To Rear Of Front Floor Console
Courtesy of GENERAL MOTORS CORP.